copy of Photocell Mirror rp 25 for garage doors

Mirror photocell for garage doors RP 25 compatible with any make and model of motor or automatic garage or parking door center and industrial applications, obstacle sensor

Thanks to its internal regulation of the light beam by screws make it very easy to install, it is also insensitive to external light sources and can be placed in any weather condition.

Reflection photocell RP25

Power supply 12/24v

Contacts NO/NC

Description of the functions:
Polarizing filter: It also reliably recognizes bright objects between the photocell and the reflector.
Powerful: Offers guarantees against dirt, rain, snow and fog.
Optional cable input: The box includes 2 possible cable inputs that can be used. The cable input can be made from below or from behind breaking in each case the part that is desired.
Insensitive to external light sources
The functions of the photocell are not damaged by external light or solar radiation.
High protection mode: The housing is hermetically sealed making it suitable for outdoor use.
Relay output:
Potential-free switching contact
Against reverse polarization:
The photocell is protected against reverse polarization of the supply voltage.
Junction box:
The RP20/RP25 has a large junction box.
The tow press can also be removed for easy connection.
Adjustment screws:
The photocell is adjusted by the three screws inside the box to achieve the final focus.
Dirt indicator:
If the photocell gets dirty little by little, then the red LED starts flashing before the photocell malfunctions.
Adjustment indicator:
The LED indicator flashes red, when the photocell is not properly adjusted to the reflector. When the LED turns green, the setting is correct.

The RP20/RP25 reflection photocell has been specially designed for door installations and offers the optimal solution for this type of application.

Warning: The photocell changes from the emission state to the test state when GND mass is connected to Terminal 1. When there is contact with a light signal, the relay is
keeps activated when the light beam is free.

Warning: The introduction of the cable at the bottom of the housing is signposted. The washer is placed
rubber and cable tow press (both included in the shipment).

The photocell can be adjusted by the three inner screws after the assembly of this. The circuit is mounted on springs. All screws come from the factory already with a given turn and at most support 3 turns. The photocell is well adjusted, when the LED-indicator glows green permanently.